Selling fabrication equipment?

KD Machinery buys used fabrication machinery outright. Tell us what you have and how to reach you, and we will get back to you. The make and model are enough to start.

How it works and what we buy: Sell your used fabrication machinery.

KD Machinery buys single machines, and whole shops and plants, outright. Auction-based plant liquidations and formal USPAP appraisals are handled by KD Auctions: see plant liquidation by auction and USPAP appraisals.

Recently Sold

Sold by KD Machinery and no longer available.

Browse every machine KD Machinery has sold → Sold Machines archive

Buying a used plate roll

Plate rolls are specified by the plate they can handle — width, thickness and the minimum diameter they can reach — and by the roll configuration.

Three-roll initial-pinch machines are the simplest and cheapest, but they leave a flat unbent section at both ends of the plate. Three-roll double-pinch and four-roll machines pre-bend both ends, producing a rounder cylinder with less scrap and less secondary work. A four-roll machine also grips the plate throughout, which makes it faster and easier to load single-handed.

Ratings are given for mild steel at a stated yield strength. Rolling higher-strength or stainless plate, or rolling to a tighter diameter than the machine is rated for, both reduce effective capacity. Work from the manufacturer’s chart rather than the headline figure.

On used machines, inspect the rolls for wear, scoring and deflection, and check the crowning. Re-machining or replacing a roll is one of the largest single costs on an older plate roll. Hydraulic condition and the state of the controls come next.

KD Machinery stocks used plate rolls from Davi, Faccin, Roundo, Bertsch, Baileigh, MG, Roccia, IMCAR, Lemas and Haeusler.

Plate Rolls

Advanced Filters

Selling fabrication equipment?

Recently Sold

Buying a used plate roll